===========================================================================
 Universal RAID Utility Ver4.02 (Linux Edition)
 for NEC Express5800/Scalable HA Server
===========================================================================
                                                            NEC Corporation
                                                                   Mar 2016

[Contents]
  1. Software Introduction
  2. Applicable model
  3. Installation Procedure
  4. General Notice
  5. Revision History
---------------------------------------------------------------------------

1. Software Introduction
Universal RAID Utility (hereinafter called "this software") is RAID System
Management Utility for the following applicable models.

2. Applicable model
  <Express5800 server>
  - Express5800/A1020b
  <RAID Controllers>
  - NE3203-174 RAID Controller (1GB, RAID 0/1/5/6)
  For users who will install following Linux on NEC Express5800 series.
  - Red Hat Enterprise Linux 6.4
  - Red Hat Enterprise Linux 6.5
  - Red Hat Enterprise Linux 6.6
  - Oracle Linux 6 Update 4 Unbreakable Enterprise Kernel R2

3. Installation Procedure
  Refer to the "Universal RAID Utility User's Guide" which is contained
in the installation image for the detailed procedure of the installation.

4. General Notice
  (1) Restart of the server after Universal RAID Utility installation
      /update/uninstallation by ExpressUpdate.
      When you install, update, or uninstall Universal RAID Utility with
      the Automatic Reboot checkbox checked, "Installation Failed" or
      "Reboot Required" may be displayed as the current status. 
      In this case, the installation, update, or uninstallation has
      been successfully finished. However, you must restart the server
      where you install Universal RAID Utility. If you leave the server
      without restart, Universal RAID Utility will not operate properly.

5. Revision History
  2016/3/31  Ver4.02 Rev 2879
  First version released.


