Changing Behavior Modes

Perform the following steps to change the behavior mode and parameters:

  1. In the Change Personality page, select the Change Auto-configure behavior check box.
  2. From the Select Behavior Mode drop-down list, select an appropriate behavior mode.
    The available behavior modes are based on the current firmware support.
    • Unconfigured Good/NONE – If a user selects this option when a new disk or an old disk with no DDF (Data Disk Format) metadata is inserted in the system, it becomes Unconfigured Good Drive. The Unconfigured Good Drive keeps in Unconfigured Good after a reboot.
    • JBOD – If all the physical drives are in unconfigured good state, once you select the JBOD mode, all the physical drives are automatically converted to JBOD physical drives. When a new disk or old disk with new DDF metadata is inserted in the system, it becomes a JBOD. The Unconfigured Good Drive is automatically converted to JBOD after a reboot.
    Note:

    For firmware versions earlier than 52.26.3-5250, Auto-Configure behavior is set to JBOD and cannot be configured for all the controller models.

    For firmware versions 52.26.3-5250 or later, Auto-Configure behavior can be configured.

    For HPE MR200 controllers, by default it is set to JBOD.

    For HPE MR400 controllers, by default it is set to None.

    Figure 1. Change Personality Dialog
  3. Select the appropriate behavior mode and click Change.