Installing in Noninteractive Mode

You must log in to the system with root privileges. You can also open the command prompt as root and run the installer through the command line.

Perform the following steps to install the LSI Storage Authority software in noninteractive mode:

  1. From the command line, run the vcredist_x86.exe /Q command to install the Microsoft Visual C++ 2008 Redistributable Package for x86 if it is not already installed.

    The Microsoft Visual C++ 2008 Redistributable Package for x86 (vcredist_x86.exe) is available under the directory <Package_Dir>\ISSetupPrerequisites\{270b0954-35ca-4324-bbc6-ba5db9072dad}\VC Redist 2008 Installation.

    OpenSLP is bundled with LSA 2.2 and later. While installing LSA, if OpenSLP is not installed ensure that you select the option to install OpenSLP, and LSA seamlessly installs the required version of OpenSLP. See OpenSLP for more information.

  2. Depending on the type of installation required, run the setup.exe /s /v/qn ADDLOCAL= command. The types of installation and their associated alert notifications available are as follows:
    Type of Installation Type of Event Notification Event Notification Choice
    Gateway Since Last Shutdown 0
    StandAlone Since Log Clear 1
    DirectAgent Since Last Reboot 2
    Light Weight Monitor Start From Now 3

    Example: If you require the Light Weight Monitor to be installed, you must to run the setup.exe /s /v/qn ADDLOCAL=LightWeightMonitor INSTALLATIONCHOICES=129 INSTALLDIR=CustomDirecotryLocation command.